Low Frequency Oscillator 2 With adjustable waveform, 3 outputs, Frequency range selectable, Eurorack format, Width: 8 HP, Depth: 45 mm, Power requirement: +20 mA (+ 12V) / -20 mA (-12V)
Bus Access Module (BAC) An active bus access module (BAC) to feed CV and gate into the bus via a jack plug (ex., with several A-100 racks or an external MIDI-CV / gate interface), Alternatively, the module can also be...
24 dB Low Pass Filter SSM Based on the chip SSM2044, Width: 8 TE / 8 HP / 40.3 mm, Depth: 45 mm (measured from the rear of the front panel), Power Requirements: 30 mA (12 V) / A -20 m (-12 V)
ADSR Envelope Generator The module A-140 is a envelope generator and since it delivers control voltages, belongs to the modulation-modules. As soon as the ADSR is triggered at gate-input, it generates an adjustable...
Euro Rack Module Provides 3 adjustable DC voltages, Adjustable voltage range: 0 - 5 V or -2.5 to 2.5 V, Euro rack format, Width: 8 HP, Depth: 40 mm, Power consumption: +20 mA (+12V)/ -10 mA (-12V)
Low-Pass Filter 6 / 12 / 24 / 48 dB Module A-108 is a completely new voltage-controlled low pass / band pass filter based on the well-known transistor ladder (Moog ladder). The module has an internal 8-stage low-pass...
Eurorack Module Voltage-controlled 24 dB low-pass filter, Cut-off frequency can be set manually or via control voltages, Two CV inputs, Power requirement: +20 mA (+12 V) / -10 mA (-12 V), Dimensions: 8 TE / 8 HP / 40.3...
Multi-Connector (2x 4 multi-port distributors)The A-180 module is a simple, passive multiple distributor. It contains two groups, each with 4 connected sockets, so that you can "multiply" the input or output of a...'
Sampler / Wavetable moduleThe A-112 Module is a combined module of a voltage-controlled 8-bit sampler and a wavetable oscillator. Moreover, it is able to produce effects. It is available as a supplemental sound...
24 dB Low Pass 1 (VCF1)Module A-120 is a voltage-controlled 24 dB low-pass filter, which filters out the high frequency components from a sound spectrum while allowing the low frequencies to pass unhindered. The cut-off...
Spring reverb module The Doepfer A-199 is a spring reverb module that via the aid of spiral springs electronically reproduces the reverb effect. Spring system with 3 separate springs, Reverb signal can be on the...
Mini PSU / Backplane Module comes preassembled and tested, +/- 12V @ 200 mA and +5V @ 50 mA, Integrated backplane with 4 slots, Especially for applications with just one or a few modules (max. 200 mA, max. 4 modules),...
MS20 Low-/ High-Pass Filter MS20 filter clone, Width: 14 HP / 70.8 mm, Depth: 40 mm (measured from the rear side of the front panel), Power requirement: +30 mA (+12 V) / -20 mA (-12 V)
Multi-Port Distributor Contains two 6.3mm / 3.5mm multiples, each with a 6.3mm and 2 x 3.5mm jack jacks, One multiple is mono (ie the two small jack sockets are connected to the tip of the 6.3 mm jack socket), The...
Dual Voltage Inverter Dual voltage inverter, When applied to the input, the voltage is inverted (for example from 5 V to -5 V inversion) and is available at the output, Two LEDs are used for voltage control of the...
Dual Voltage-Controlled Amplifier Module A-132 contains two voltage-controlled amplifiers with linear characteristic, which are designed mainly to control the amplitude of the control signals, for example: ADSR amount,...